A wide chimney can act like a dam. Rain and melting snow run down the slope, hit the uphill face, and sit there. That pocket is where many Northeast Pennsylvania chimney leaks start, and a roof cricket is the small peaked structure built to split that water to either side.

A roof cricket, also called a saddle, is not flashing by itself and it is not a second roof over the whole house. It is a diverter on the ridge side of a chimney, curb, skylight, or other wide penetration. The Pennsylvania residential code calls for one when that penetration is more than 30 inches wide, measured across the slope. Narrower chimneys can still hold snow in this climate, so the useful question is whether water has a path around the obstacle.

This guide covers what the cricket does, and when the 30-inch rule applies. It also covers how steep-slope and low-slope versions differ, and what to look for before you ask for an estimate. The saddle is part of ordinary residential roofing when the chimney is on a house. If water is already inside, the steps to take for a roof leak come first. The cricket decision comes after the ceiling is safe.

Request a free estimate if the chimney has no diverter, or call (570) 793-5715.

What a roof cricket does on a sloped roof

Picture a small tent pitched against the back of the chimney, with the peak pointing uphill toward the ridge. Water that used to stop at a flat wall now hits a slope and turns left or right. That is the whole job of a roof cricket. Roofers also call it a saddle, and the two names mean the same detail.

The cricket sits on the ridge side only. The downhill face of a chimney still needs flashing, and so do the sides. A cricket does not replace those pieces. It changes the shape of the roof so water reaches the flashing as a moving sheet instead of a pond. On a shingle roof, the cricket is usually a small framed deck covered with the same shingles or with sheet metal. Then tied into the chimney with step and counterflashing.

You will also see crickets behind skylight curbs, HVAC curbs, and the uphill side of a wall where a lower roof dies into it. The idea is the same each time: do not let water stop against a vertical face. Valleys are a different problem. A valley collects water from two slopes into one channel. A cricket does the opposite. It breaks one flow into two. If stains track to the folded metal between two roof planes, start with valley leak causes, not a cricket.

From the ground, a cricket looks like a little ridge tucked behind the chimney. On a metal roof it may be a shop-formed diverter in the same panel color. On a low-slope commercial roof it may be a wedge of tapered insulation you only notice because water no longer sits at the curb. None of those shapes is decorative. If the peak is flat, or if one side dumps water into a corner with no outlet, the cricket is not doing the job.

When a chimney needs a roof cricket

The Pennsylvania residential code is specific. Section R903.2.2 says a cricket or saddle shall be installed on the ridge side of any chimney or penetration more than 30 inches wide. Measured perpendicular to the slope. The covering must be sheet metal or the same material as the rest of the roof. That text is in the 2009 Pennsylvania Residential Code. Later model codes keep the same 30-inch trigger and add a narrow exception for some factory skylights that are flashed the way the manufacturer requires. Your township’s adopted code, and the inspector on the permit, control the job in front of you.

Measure the chimney the way the code does. Stand so you are looking across the slope, not up it. The width that matters is the face the water hits, not the taller dimension running with the rafters. A chimney that is 36 inches across the slope and only 16 inches up the slope still trips the rule. A chimney that is 16 inches across the slope does not, even if it is tall.

A code trigger is not the only reason to add one. Northeast Pennsylvania roofs carry long snow loads, then warm days that melt the uphill side while the eave stays frozen. A chimney only 24 inches wide can still hold a drift. If you already see a stained chimney chase, lifted shingles just above the brick. Or a dark line in the attic along that bay, the width rule is beside the point. Water has already found the pocket.

The rule does not say every chimney gets a cricket. And it does not say a cricket fixes a leak that is really a bad counterflashing joint or a cracked crown. Those are separate repairs. What the rule does say is that once the uphill face crosses 30 inches, the roof needs a diverter. And the diverter has to be covered like a roof, not left as bare wood.

Source: Pennsylvania Residential Code 2009, R903.2.2, via UpCodes, Chapter 9 roof assemblies.

Steep-slope and low-slope roof cricket types

People search “types of roof crickets” and get two answers mixed together. One is the little saddle behind a house chimney. The other is a tapered wedge on a flat commercial roof. They share a purpose and almost nothing else about how they are built.

Type Where you see it How it is built What to confirm
Steep-slope chimney saddle. Asphalt, metal, or tile roofs behind a chimney or wide curb. Small framed deck, then shingles or sheet metal, flashed into the chimney. Both sides drain, and the metal laps under the field shingles uphill.
Low-slope or flat cricket. Rubber, built-up, or membrane roofs at curbs, hatches, and equipment. Tapered insulation or a built-up diverter under the membrane. Water reaches a drain or scupper instead of a new pond.
Metal diverter. Standing-seam or agricultural panels, and some shingle crickets. Formed metal saddle in a compatible metal, seamed into the panels or flashing. The metal matches the roof and is not a rusty patch panel.

On a house, the saddle should disappear into the roof. The uphill edge tucks under the course of shingles above it. The sides die into roof flashing around chimneys, with counterflashing cut into the mortar joint or reglet, not face-caulked to the brick. Caulk is a gasket, not a plan.

On a commercial roof, the cricket is often insulation. Crews set tapered boards so the high point is against the curb and the low points fall toward drains. The membrane goes over that shape in one system. A cricket that creates a new birdbath ten feet away has only moved the leak. If the building has a rubber or membrane roof, the diverter belongs in that system, which is part of commercial roofing, not a shingle detail borrowed from a house.

MNM Roofing covers both kinds of roofs across the Poconos, Luzerne County, and the Lehigh Valley, with in-house crews rather than a separate flashing subcontractor. The right cricket is the one that matches the roof already on the building.

Why Pennsylvania snow changes the cricket decision

A cricket in a mild climate mostly handles rain. Here it also handles a pile of snow that melts from the bottom. The chimney shades the uphill side and blocks the slide path. Snow packs there, the roof deck underneath stays warmer than the eave, and meltwater runs into a pocket that cannot drain. When that water refreezes overnight, it lifts shingles from behind. That is a different ice problem from the dam that forms at a cold gutter line.

Eave ice dams still matter, and they have their own fixes: ventilation, air sealing, and ice-and-water membrane at the eaves. A chimney cricket will not stop those. If the damage is along the gutter, read the ice dam roof damage signs before you blame the chimney. If the damage is a streak on the ceiling beside the chimney. Or granules and grit piled on the uphill brick, the pocket behind the chimney is the place to look.

Wide chimneys on older NEPA houses are common. Many of those roofs were installed before anyone measured the 30-inch face. Or the cricket was framed and then covered with a single piece of metal that was never laced into the shingles. Snow finds that shortcut. A replacement is the clean time to add the saddle, because the deck is open and the new underlayment can run continuously under the cricket. Adding one on a roof you plan to keep is still possible. It means opening shingles above and beside the chimney, building the diverter, and reflashing. It is not a tube of sealant.

Metal roofs shed snow faster, which sounds safer and sometimes is not. A panel run that dead-ends on a chimney can drop a slab of snow and ice against the brick, then leave meltwater in the same pocket. The diverter still belongs on the uphill side, formed so the panels do not create a dam of their own. That work sits with metal roof repair when the panels are already in place, and with a full residential roofing replacement when the system is being redone.

Signs the cricket is missing or failing

You can learn a lot from the yard and the attic before anyone walks the roof. Do not climb a snowy or steep slope to check. These are the patterns that justify a professional roof inspection.

  1. Look uphill of the chimney from the ground. You should see a small ridge, not a flat shelf of shingles dead-ending into brick. No ridge on a chimney wider than 30 inches across the slope is the code gap.
  2. Check the uphill brick and the shingles just above it. A permanent dark band, grit piled against the masonry, or shingles curled only in that pocket means water is stopping there.
  3. Look in the attic along the chimney bay after a rain or a thaw. Wet decking, dark rafters, or a stain that starts at the uphill face and runs downhill points at the pocket, not at a random shingle.
  4. Read the flashing, not just the shape. A cricket with gaps at the counterflashing, face caulk smeared over brick, or metal that is rusted through is a failed diverter even if the peak looks right.
  5. Compare the leak to the weather. A drip that shows up the day after a thaw, only beside the chimney. Is a different story from a leak in the middle of a wind-driven rain on an open field of shingles.

One miss people make is blaming the cricket for a leak at the front apron, the downhill side. Water overshoots a short apron and runs behind the chimney breast. That is a flashing repair. Another miss is calling a roof valley a cricket. They are both metal and they both move water, and that is where the similarity ends.

If the saddle is there and the leak is old, the deck under it may already be soft. Re-covering a rotten cricket hides the damage until the next thaw. The inspection should say whether the framing is sound before anyone prices a new metal cap.

What to compare on a roof cricket estimate

There is no honest single price for this work. A saddle tied into an open replacement is a small part of a larger job. A saddle cut into a finished 20-year-old roof, on a steep pitch, with a chimney that needs new counterflashing, is a different job. Width, pitch, height, roofing material, and whether the deck is soft all move the number. Ask for the scope in writing instead of a verbal “we’ll add a cricket.”

A useful estimate names the chimney width measured across the slope. It names the cricket covering, sheet metal or the field roofing. It says how the uphill edge tucks under the course above, and how the sides tie into counterflashing. It should also say whether any sheathing is included if the deck is soft, and whether ice-and-water membrane runs through the pocket. If the note is only “seal chimney,” you are buying caulk.

Ask who builds it. MNM Roofing Professionals does this work with in-house crews out of Greentown, Nanticoke, and Whitehall Township, and the owner reviews the estimate. That matters on a detail this easy to fake from the ground. You want the same crew that opens the roof to close the flashing. Not a handoff between a roofer and a mason who each think the other lapped the metal.

Timing belongs in the same conversation. If the shingles are near the end of their life, building a cricket and then tearing off the roof two years later means flashing it twice. The repair versus replacement choice should come before the cricket price. If the roof has years left and the chimney is the only wet spot, a targeted rebuild is reasonable.

Edge metal is a separate line. Drip edge kicks water off the eave. It does not divert water around a chimney. Gutters matter where the two new channels dump their water, and a gutter that cannot take the extra flow will overflow at the corner nearest the chimney. Mention that on the visit so it is not a surprise after the first hard rain.

Ask MNM Roofing to measure the chimney before the next thaw.

Frequently asked questions

Is a chimney cricket necessary?

It is required by the Pennsylvania residential code when the chimney or penetration is more than 30 inches wide across the slope. Narrower chimneys are not automatically exempt from trouble. In a snow climate, a smaller chimney can still trap a drift. If you see staining or lifted shingles uphill of the brick, treat it as necessary even when the width rule does not force it.

Is a roof saddle the same thing as a roof cricket?

Yes. Saddle and cricket are two names for the peaked diverter on the ridge side of a chimney or curb. If an estimate says “saddle” and another says “cricket,” ask both contractors to describe the location and the covering. The name is not the difference. The flashing and the drainage are.

How much does a chimney cricket cost?

Nobody can price it fairly without seeing the chimney, the pitch, and the roof condition. Added during a replacement, it is a small part of the roof. Cut into an older roof, with new flashing and possible deck repair, it costs more because the roof has to be opened and closed. MNM Roofing gives free estimates and does not publish a flat cricket price, because the jobs are not flat.

What are the main types of roof crickets?

The three you will actually see are easy to tell apart. One is a framed saddle on a steep shingle or tile roof. One is a formed-metal diverter on a metal roof. One is a tapered-insulation cricket under the membrane on a low-slope commercial roof. All three send water sideways. They are not interchangeable parts.

Can a cricket be added without replacing the whole roof?

Often, yes, if the surrounding shingles or panels are still sound and the deck under the pocket is solid. The crew opens the courses above and beside the chimney, frames or forms the diverter, and reflashes it. If the field of the roof is failing, do the cricket with the replacement so the underlayment is continuous.

Ask for a look before the next thaw

If the chimney is wider than 30 inches and you cannot see a diverter behind it, get it checked. The same is true if the ceiling beside the chimney stains after a thaw. Do it while the deck is still dry. MNM Roofing Professionals will measure the uphill face, check the flashing, and tell you whether a cricket belongs in a repair or in a replacement.

Call (570) 793-5715 or request a free estimate. Crews work from Greentown, Nanticoke, and Whitehall Township across Northeast Pennsylvania, and the estimate is reviewed in house.